Component Identification - M-system R7 Series Instruction Manual

COMPONENT IDENTIFICATION

■ SIDE VIEW
Terminating Resistor SW
■ STATUS INDICATOR LED
ID COLOR
Turns on when the internal 5V is sup-
PWR Green
plied normally.
Turns on when the refresh data is re-
RUN Green
ceived normally.
■ STATION ADDRESS
The left switch determines the sixteenths place digit, while
the right switch does the ones place digit of the address.
The data allocation is 4.
• Full-duplex communication
Setting "n" with the rotary switches, the addresses are n,
n+2, n+4 and n+6. (Range: 01H to 39H)
• Half-duplex communication
Four (4) addresses are assigned from the one set with the
rotary switch. (Range: 01H to 3CH)
Station Address Setting (x1)
Station Address Setting (x16)
SEN TRONIC
■ FRONT VIEW
Station Address Setting Rotary SW
Status Indicator LED
PWR RUN
4 5
1
FUNCTION
056 222 38 18 mailbox@sentronic.com
AG
1 2 3 4 5 6 7 8
X10 X1
STATION ADD.
6 7 10 11 12 13
2 3 1 2 3 4
Network, Power Supply
Terminals
■ OPERATING MODE
(*) Factory setting
• Burnout (SW1-2)
SW1-2
OFF
ON
• RTD type (SW1-3, 1-4, 1-5, 1-6)
SW1-3 SW1-4 SW1-5
OFF OFF OFF
ON OFF OFF
OFF ON OFF
ON ON OFF
OFF OFF ON
ON OFF ON
OFF OFF OFF
ON ON ON
• Transfer rate (SW1-8)
SW1-8
OFF
ON
Note: Be sure to set unused SW1-1 and 1-7 to OFF.
■ TERMINATING RESISTOR
To use the terminating resistor, turn the switch ON, and
OFF to invalidate. (Factory setting OFF)
www.sentronic.com
R7HL-RS4
Operating Mode Setting DIP SW (SW1)
PC Configurator Jack
ON
CNFG.
14 15 16 17 18
5 6 7 8 9
Input Terminals
BURNOUT
Upscale (*)
Downscale
SW1-6 RTD TYPE
OFF Pt 100 (JIS '97, IEC) (*)
OFF Pt 100 (JIS '89)
OFF JPt 100 (JIS '89)
OFF Pt 50 Ω (JIS '81)
OFF Ni 100
OFF Cu 10 @ 25°C
ON Cu 50
ON PC Configurator setting
TRANSFER RATE
12 Mbps (*)
6 Mbps
EM-7812-C Rev.4 P. 2 / 5