Table of Contents
Advertisement
FOR CUSTOMER SERVICE CALL: 800-750-2723 EXT 5050
TOOLS AND MATERIALS
You will need the following items for installation:
• A Phillips Head screw driver.
• A ratchet wrench with a 7/16" and 1/2" sockets or
wrenches to install flue collar and pedestal assembly to
the unit.
• An 1/8" drill bit to drill pilot holes into the vent pipe for
securing each section.
• A non-combustible floor protector as specified in this
manual.
• All chimney and chimney connector components for your
particular chimney installation.
• Additional
items
for
buildings may be needed. See "For use in Mobile home/
transportable buildings" section of this manual.
PEDESTAL ASSEMBLY
1. Attach the pedestal back to the pedestal base using two
(2) # 10 screws.
2. Attach the left and right side panels of the pedestal to
the pedestal base using a total of six (6) # 10 screws.
3. Secure the left and right side panels of the pedestal to
the pedestal back using a total of six (6) # 10 screws
as shown.
© 2023 Breckwell Hearth
Mobile
home/transportable
ASSEMBLY INSTRUCTIONS
4. Attach the front panel of the pedestal to the pedestal
base using two (2) # 10 screws.
5. Secure the front panel of the pedestal to the left and
right side panels of the pedestal using a total of six (6)
# 10 screws as shown. NOTE: The back pedestal panel
was removed in this image for clarity purposes only. Do
Not remove the back pedestal panel when installing the
front pedestal panel.
This view is from the
inside back of the
pedestal looking out
4
Advertisement
Table of Contents
