Breckwell SW500 Operation Manual page 19

INSTRUCTIONS SPECIFIC FOR CANADIAN INSTALLATIONS
Do not obstruct the space under the heater and do not obstruct the combustion air openings.
Refer to the chimney manufacturer's instructions for disassembling the chimney for transportation of a transportable building.
This heater meets the requirements of CAN/ULC-S627 and is suitable for installation on a combustible floor and does not
require radiant floor protection.
The parts or materials to be employed for ember protectors and the minimum areas to be covered and their relation to
the space heater, as well as the notice: "In Canada, to comply with CSA B365, Installation Code for Solid-Fuel-Burning
Appliances and Equipment, any combustible covering beneath the appliance and/or within the area extending horizontally
at least 450 mm (18 in) beyond the appliance on any side equipped with a door, and at least 200 mm (8 in) beyond
the appliance on other sides, shall be protected by a continuous, durable, non-combustible pad that will provide ember
protection. The 450 mm (18 in) ember protection required on any side with a
door shall extend for the full width of the appliance plus the 200 mm (8 in) required on each side of the appliance without
a door. Where an appliance is installed less than 200 mm (8 in) from a wall, the ember pad need only extend to the
base of the wall. An ember pad shall not be placed on top of a carpet unless the pad is structurally supported to prevent
displacement and distortion.
Note: Do not install the chimney directly at the outlet of the appliance. A chimney connector (flue pipe) is required.
If this appliance is installed in a transportable building, removal of the chimney is required for transportation of the building.
DO NOT INSTALL IN AN ALCOVE
19
© 2023 Breckwell Hearth