Depth Adjustment; Cleaning The Stapler; Clearing A Jam - U-Line H-1030 Operation Instructions Manual

DEPTH ADJUSTMENT

1. Loosen front screw with a 6 mm Allen wrench.
(See Figure 10)
Figure 10
2. Push the body up and adjust to the desired depth.
(See Figure 11)
3. When the top edge of the adjustment plate is at
its highest setting, the teeth are at their shallowest
penetration. (See Figure 12)
Adjustment Plate
PAGE 4 OF 24
OPERATION CONTINUED
4. If set at No. 1 the teeth are at their deepest
penetration. (See Figure 13)

CLEANING THE STAPLER

1. Disconnect air supply from the stapler.
2. Remove tar buildup with non-corrosive cleaner.
Figure 11
3. Dry the stapler completely before use.

CLEARING A JAM

1. Disconnect air supply.
2. Pull up lever. (See Figure 14)
3. Insert needle nose pliers or screw driver to clear jam.
(See Figure 14)
4. Push down lever.
Figure 12
No. 1
No. 2 & 3
No. 4
CAUTION! Do not allow solvent to get into
the cylinder or damage may occur.
Figure 14
Figure 13
0323 IH-1030