Other Switch Operations; Routine Camera Administration And Recovery - Allied Telesis AT-X230-10GP User Manual

Usage

Other Switch Operations

To reboot the switch, click the "Reboot Switch" button. This may be done to help recover a switch
that is not performing properly, or to revert the switch's configuration to its last saved boot
configuration.
To perform other actions on the switch, click the "Open in Browser" button. This will bring up the
switch's built-in graphical user interface in your default web browser. Note that Internet Explorer is
not supported by the web-based user interface; it is recommended that you select Google Chrome
or Mozilla Firefox as your default browser.

Routine Camera Administration and Recovery

Users who are monitoring video using the "Live" tab of the Milestone XProtect Smart Client can
use a convenient interface to administratively disable a port associated with a camera or disable
power to the port. For example, a security officer may want to temporarily disable the port to stop
video from being recorded; or, the officer may want to remove and then reapply power to the port to
recover a camera that is not responding.
In the "Live" tab of the Smart Client, if the side panel at the left is not visible, click the "Show Pane"
button in the upper left corner of the screen, immediately below the tab bar.
The Allied Telesis Milestone Integration Plug-In will be available under the "MIP Plug-Ins" section of
the left panel. When a camera window is selected, and the camera has been associated with an
Allied Telesis switch and port, information about that switch and port will be shown in the plug-in
panel.
C613-02090-00 REV A Allied Telesis Milestone Integration Plug-In User Guide Page 20