Saving Your Settings And Exiting Setup - Epson Endeavor L User Manual

Saving Your Settings and Exiting SETUP

When you leave SETUP, you can either save the settings you
have changed or exit the program without saving any changes.
To save your settings, follow these steps:
1. Press
2. Select option 6, SAVE
press Enter. You see this message:
Write to CMOS RAM and exit (Y/N)?
Press Y and Enter. The system reboots
3.
4. If you have just run SETUP for the first time, see "Post-SETU
Procedures," below.
To exit SETUP without saving the setting, select option 7,
w i t h o u t s a v i n g s e t t i n g s . T h e s y s t e m r e b o o t s
E x i t
with your original settings.
N o t e
If your computer detects a problem in your SETUP
configuration, you may see an error message and a prompt
to run SETUP when it is rebooting. Follow the instructions
on the screen to run SETUP and correct the problem.
You may also see an error message when your computer is
rebooting if you have not installed your operating system on
the hard disk and you did not insert a system diskette in
drive A. If you receive this error message, follow the
instructions in your operating system manual to install it.
to return to the main SETUP menu
E
SC
settings and
Running the SETUP Program
and
exit,
P
2 - 1 5