Camera Problems - Epson PhotoPC 500 User Manual

Camera Problems

Before you call for help, check this list of problems and
possible solutions:
The camera has no power.
Check the power switch and make sure the camera is
turned on.
The camera may have shut off automatically. Slide the
power switch off and then on.
Check the batteries and make sure they are installed
correctly. Replace the batteries if necessary, following
the instructions on page 1-4.
If you are using the AC adapter, make sure it is plugged
into a working outlet.
You can't take a picture with the camera.
The flash may be recharging. Wait until you see the
green ready light, and try again.
The camera may be full. Check the picture counter on
the control panel. Erase a picture using the erase
button, or transfer the pictures to your computer and
then erase them. See Chapter4 for information about
transferring your pictures and Chapter 5 for
information about erasing them with your computer.
The camera may be connected to your computer.
When it's connected, you can't use any of the controls
on the camera itself. See page 5-5 for instructions on
taking pictures from your computer.
The flash doesn't work.
Make sure the flash is not set to flash off
Check the batteries and make sure they are installed
correctly. Replace the batteries if necessary, following
the instructions on page 1-4
You can't use the flash when you adjust the shutter
speed manually with the camera connected to the
computer. Set the shutter speed to automatic to use the
flash.
You get an error message when you try to transfer your
pictures to the computer
Make sure the cable is connected correctly as described
on page 3-1.
Caring for the Camera and Troubleshooting 12-3
A
B