Installing The Display Assembly - Dell Latitude 5430 Chromebook Service Manual

Steps
1. Remove the two screws (M2x3) that secure the display-cable bracket to the system board.
2. Open the latch and disconnect the display-cable from the connector on the system board.
NOTE: For models with touch display configuration, disconnect the display touch cable from the connector on the
system board.
3. Remove the three screws (M2.5x4) that secure the left display hinge to the system board.
4. Pry open the left display hinge at an angle of 90 degrees.
5. Remove the three screws (M2.5x4) that secure the right display hinge to the system board.
6. Pry open the right display hinge at an angle of 90 degrees.
7. Gently lift the palm-rest and keyboard assembly off the display assembly.
CAUTION: To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display
assembly.

Installing the display assembly

Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the installation
procedure.
46 Removing and installing components