Dell Latitude 5430 Chromebook Service Manual page 48

Steps
1. Place the display assembly on a clean and flat surface with the display panel facing up.
2. Gently place the palm-rest and keyboard assembly under the display hinges.
CAUTION: To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display
assembly.
3. Close the left display hinge and align the screw holes on the left display hinge with the screw holes on the I/O board.
4. Replace the three screws (M2.5x4) that secure the left display hinge to the palm-rest and keyboard assembly.
5. Close the right display hinge and align the screw holes on the right display hinge with the screw holes on the system board.
6. Replace the three screws (M2.5x4) that secure the right display hinge to the palm-rest and keyboard assembly.
7. Connect the display cable to the connector on the system board and close the latch.
NOTE: For models shipped with touch screen display configuration, connect the touch display cable to the connector on
the system board and close the latch.
8. Align the screw holes on the display-cable bracket with screw holes on the system board.
9. Replace the two screws (M2x3) to secure the display-cable bracket to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in
48 Removing and installing components
After working inside your computer.