Steps
1. Remove the two screws (M2x2) and remove the solid-state drive thermal bracket that secures the M.2 solid-state drive.
2. Remove the single screw (M2x2) that secures the M.2 2230 solid-state drive to the system board .
3. Slide and remove the M.2 2230 solid-state drive from the solid-state drive slot on the system board.
Installing the 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
Solid-state drives are fragile. Exercise care when handling the solid-state drive.
The following images indicate the location of the 2230 solid-state drive that is installed in M.2 slot and provides a visual
representation of the installation procedure.
Removing and installing components
25