Steps
1. Using the alignment posts, place the left and right speakers on the palm-rest and keyboard assembly.
2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
3. Adhere the tapes that secure the antenna cables to the system board.
4. Connect the speaker cable to the connector on the system board and close the latch.
5. Connect the touchpad cable to the connector on the system board and close the latch.
6. Connect the keyboard cable to the connector on the system board and close the latch.
7. Connect the keyboard-backlight cable to the connector on the system board and close the latch.
8. Connect the fingerprint reader cable to the connector on the system board and close the latch.
Next steps
1. Install the
solid-state
2. Install the
wireless
card.
3. Install the battery.
4. Install the
base
cover.
5. Follow the procedure in
Touchpad
Removing the touchpad
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
About this task
The following images indicate the location of the touchpad and provide a visual representation of the removal procedure.
34
Removing and installing components
drive.
After working inside your
Before working inside your
computer.
computer.