Activating And Using The Remote Control - Epson PowerLite 8300NL User Manual

note
If the pointer button is
pressed longer than 10
seconds, the remote control
stops operating to conserve
power. Releasing the button
resumes normal operation.
Giving Your Presentation
46
Activating and Using the Remote
Control
The remote control has an on/off switch on its side, as shown. Before
using the remote, make sure batteries are installed as described on
page 50, then push up on the on/off switch to turn it on.
Turn off the remote control before transporting or storing it; this
prevents the batteries from discharging if something presses against
one of the buttons.
Here are some additional tips:
Point the remote control either at the front or back of the
projector, or at the screen.
Stand within about 30 feet of the projector. If you want to operate
the projector from a greater distance, a remote control cable set is
available (see page 12).
When presenting in a darkened room, press the
make the buttons on the remote light up temporarily.
Avoid using the remote under bright fluorescent lamps or in
direct sunlight, or the projector may not respond properly.
On/off switch
light button to