Connecting To The Bnc Port - Epson PowerLite 8300NL User Manual

note
The connectors on your cable
may be labelled, or they may
be color-coded (black for
H/C Sync and gray for
V Sync).
Setting Up the Projector
24

Connecting to the BNC Port

1. Depending on your computer's connection, obtain the correct
type of BNC cable (these cables are commercially available):
If your computer has a VGA port, use a VGA–5BNC cable.
If your computer provides video output through BNC
connectors, use a 5BNC–5BNC cable.
2. Connect the cable to the projector's
the red, green, and blue connectors to the corresponding
and ports on the projector. Then plug the remaining two
B
connectors into the corresponding H/C Sync and V Sync ports.
3. Connect the other end to your computer's video-out or monitor
port.
4. Optionally, you can connect an external monitor (see page 28),
play sound through the projector (see page 29), or connect a USB
cable to use the remote control as a mouse (see page 27).
5. If you don't need to make any other connections, see Chapter 2
for instructions on turning on the projector and adjusting the
image. Once the projector is turned on, be sure to:
Enter the projector's Setting menu, then make sure the BNC
Input is set to
page 70).
After exiting the menu system, select
your image (see page 34).
BNC
R G B
(this is the default setting; see
Analog-RGB
BNC
port as shown. Connect
, ,
R G
as the source to see