Disabling The Projector's Buttons - Epson PowerLite 62c User Manual

note
To cancel Operation Lock,
press the projector's
Enter
button for seven seconds.
Fine-tuning the Projector
70
If the password is not correct, you see the message
If you enter an incorrect password three times in
Please try again.
succession, you see the message
locked. Request code xxxxx
mode for approximately 5 minutes. Write down the request code.
Then disconnect the projector's power cord from the electrical outlet,
reconnect it, and turn the projector back on.
When you see the Password Protect Release screen again, you can try
to enter the correct password.
If you have forgotten the password, contact Epson with the request
code number that appears in the Password Protect Release screen for
assistance. See "Where To Get Help" on page 95.
If you enter an incorrect password 30 times in succession, the
projector remains locked and you must contact Epson to unlock it.

Disabling the Projector's Buttons

When you enable the Operation Lock function, all the projector's
buttons are disabled except for the P
1. Press the button.
Menu
2. Select the
Settings
3. Use the pointer button (or up and down arrow buttons) to
select
Operation Lock
4. Select and press
ON
5. Select and press
Yes
6. Press the button.
Menu
The projector's operation will be
and the projector switches to standby
button.
Power
menu and press .
Enter
and press the
Enter
.
Enter
to confirm the setting.
Enter
Wrong password.
button.