Adjusting The Volume; Shutting Down The Projector - Epson PowerLite 62c User Manual

note
You can also adjust the
volume using the projector's
Settings menu. See page 60
for details.
You must adjust the volume
separately for each input
source.
note
When the projector has not
received any input signals for
30 minutes, it automatically
turns off the projector lamp
and enters "sleep mode." This
conserves electricity, cools the
projector, and extends the life
of the lamp. If you are done
using the projector, unplug
the power cord. If you want
to start projecting again, press
the P button. You
Power
can turn sleep mode on or off
through the Extended menu.
See page 63.
Projecting
42

Adjusting the Volume

You can use the buttons on the remote control or projector to increase
or decrease the volume for both the projector's built-in speaker and
external speakers connected to the projector. Press the
increase the volume, or the
appears on the screen while the volume is being adjusted.

Shutting Down the Projector

When you've finished using the projector, follow the recommended
procedure to shut it down.
1. If you're using a computer, shut it down first; otherwise you may
not be able to see your computer's display to shut it down
properly.
2. To turn off the projector, press the P
projector or remote control.
You see this confirmation message:
(If you don't want to turn it off, press
any other button or wait a few
seconds until it disappears.)
3. Press the P
Power
lamp is turned off, and the power light turns orange.
With Epson's exclusive Instant Off
cool-down period, so you can pack up and go immediately after
turning off the projector.
button to decrease it. A volume gauge
Volume controls
Power
button again. The projector beeps twice, the
™
technology there's no
button to
button on the