Epson PowerLite 62c User Manual page 63

■ Projection
Projector is in front of the screen.
Front:
Front/Ceiling:
upside-down from the ceiling.
Projector is behind the screen.
Rear:
Rear/Ceiling:
upside-down from the ceiling.
■ Operation
Direct Power:
as soon as you plug in the power cord. You don't have to
press the P
Power
Sleep Mode:
off the lamp if it has not received any input signals for 30
minutes.
High Altitude Mode:
altitude above 4,921 feet, turn this setting on to ensure that
the internal temperature of the projector is regulated
properly. Turn this setting off for lower elevations.
■
Standby Mode:
projector over a network and perform other network
functions when the projector is in standby mode.
■
COM Port
Turn on
USB
computer with the EMP Link 21L software. This software
can be downloaded from the Epson website at
support.epson.com. (You must turn the projector off and
then on again to use the new setting.)
■
Language
Select the language to be used for the projector menus.
4. When you're finished, press
Projector is in front of the screen, mounted
Projector is behind the screen, mounted
When this feature is enabled, projection starts
button.
When Sleep Mode is on, the projector turns
When using the projector at an
Set to
Network ON
only if you're controlling the projector from a
or
Esc Menu
to monitor your
.
note
When
Direct Power
is turned on, press the
button to turn
P Power
the projector off, wait until
the P power light turns a
steady orange, then unplug
the power cord.
Fine-tuning the Projector
63