Connecting To A Wired Network - Epson PowerLite 1725 User Manual

note
Only the Epson Ethernet
unit is guaranteed to work.
Other brands may not be
compatible.
If you see a message asking
you to insert a LAN or
memory card, check to make
sure your Ethernet unit is
properly inserted.
Setting Up Network Projection
90

Connecting to a Wired Network

With the optional Ethernet unit, you can connect the projector to
your network and configure it with an IP address. This provides an
alternative to connecting to the projector wirelessly.
1. Remove the wireless module and cover plate, as described above,
then insert the Ethernet unit into the projector and replace the
cover plate.
2. Connect the projector to your network using a commercially
available 100BaseTX or 10BaseT network cable. Connect the
cable to the port on the projector.
LAN
3. Point the remote control at the projector and press the P
button.
4. Press the
EasyMP
as the source.
5. Press the button on the remote control, select the
Menu
menu, then press
Network
6. Choose
Network Configuration
7. Choose
Wired LAN
screen:
8. Do one of the following:
button on the remote control to select EasyMP
.
Enter
and press
and press . You see the following
Enter
Power
.
Enter