Enabling Password Protection - Epson PowerLite 1725 User Manual

note
It's a good idea to write
down your password.
If you leave the projector
plugged in, the Password
Protect Release screen will
not appear. You only need a
password if you unplug and
reconnect the power cable.
caution
If you lose the remote
control, you will not be able
to enter the password. Keep
the remote control in a safe
place at all times.
Fine-Tuning the Projector
106
If you create a user's logo for the projector, you can set up the logo so
it is displayed as the startup screen and/or A/V Mute screen.
Unauthorized users cannot turn it off or change it. This feature is
intended to discourage theft and provides a way to identify the
projector should it be stolen.

Enabling Password Protection

To prevent unauthorized use, you can assign the projector a password.
If you do, a screen will appear requesting the password whenever the
projector is plugged in and turned on. If an incorrect password is
entered three times in succession, the projector's operation is locked
and the power cord must be disconnected and reinserted to redisplay
the password screen. If an incorrect password is entered thirty times in
succession, the user must contact Epson to unlock the projector.
The default setting for the Password Protect function is
these steps to turn password protection on:
1. Press the button on the remote control for about five
Freeze
seconds.
You see this screen:
2. Use the pointer button to set
Then press .
Enter
3. Press
Esc.
4. Select and press
Password
5. When you see a message asking if you want to change the
password, select
Yes
Power On Protect
.
Enter
and press .
Enter
. Follow
Off
to .
On