Using Quick Wireless Connection - Epson PowerLite 1725 User Manual

note
The USB key is stored in a
small pouch inside the
carrying case. Do not
attempt to write to the key
or use it as a flash memory
drive. To replace a lost or
missing key, contact Epson
(see page 12).
note
The Quick Wireless
Connection utility will
disable any other wireless
sessions and adapter
programs. Make sure you
leave the USB key in your
computer for your entire
Quick Wireless Connection
session. Follow the
instructions on this page to
remove the USB key when
you are finished with the
session.
Setting Up Network Projection
54

Using Quick Wireless Connection

Using the USB key that came with your projector, you can quickly
connect the projector to a Windows computer without any
configuration.
First, make sure you have installed the wireless module and turned on
the projector as described on the Quick Setup sheet.
1. Connect the USB key to the projector's
port.
2. When you see a projected message that the network information
update is complete, remove the USB key.
3. Connect the USB key to a USB port on your computer or
notebook.
In Windows Vista, if you see the AutoPlay window, select
Run LaunchU3.exe
screen, click
Allow
4. When you see a license agreement, click
Quick Wireless Connection driver.
If you see a Windows Firewall message, click
firewall.
After a few minutes, your computer image will be displayed
through the projector. If not, try restarting your computer.
5. When you're done with your presentation, remove the USB key.
You may need to restart your computer to reactivate your wireless
interface.
. When you see the User Account Control
.
Agree
(flat) USB
Type A
to install the
to disable the
Yes