Table of Contents
Advertisement
CHANDLER
ENGINEERING
TITLE: Procedure, 5270 Configuration for 4207D
Instrument Model: Model 4207D Compressive Strength Tester
Using Tools > Configure > Instruments, select the Model 4207D Compressive Strength Tester from the list of
available instruments.
Assign a name and file prefix. These choices may vary as desired.
Define the signal I/O addresses as described below
•
Load – Prog (Input Signal)
o
Address: 1:3076f
o
Units (Raw and Calibrated): Lbf
•
Load – Maximum (Input Signal)
o
Address: 1:1555f
o
Units (Raw and Calibrated): Lbf
o
Advanced > Setpoint 1: 1:1554u (this setpoint allows 5270 to reset the maximum at the start of
the test)
•
Load (Controller)
o
Address: 1
o
Setpoint units: Lbf
When Configuring a Test Profile, select the Start Sequence tab and configure as shown below.
Part Number: 89-0175
Page 2 of 2
Advertisement
Table of Contents
