Table of Contents
Advertisement
SECTION 2 – OPERATING INSTRUCTIONS
2-2
Program Status: Indicates the current Program Step:
Manual Mode: Indicates Manual Mode has been selected. In Manual Mode, the Raise and
Lower buttons operate on the Output Power. In Automatic Mode (this icon is off), the Raise
and Lower buttons operate on the Set Point.
Output Indicators: Illuminate when the appropriate output is activated. Output 1 is the
Output Power sent to the Hydraulic Power Unit. The other outputs are unused.
F1: Toggles between Automatic and Manual mode. When in Manual Mode the "hand" icon
is illuminated.
F2: Program Run / Reset. Press once to Start the program. Press again to Reset the program.
Page: Used to page through the various menus in the controller.
Scroll: Used to scroll through the parameter settings within a menu page.
Note: Press Page + Scroll to return to the "Home" Display. When at the Home Display, Page
+ Scroll will acknowledge any alarm.
Lower / Raise: Used to change the value of a parameter. Press and hold the button for rapid
changes.
Configuring the controller to perform a sample load program involves defining a series of
ramp and dwell segments.
Once the program exists, the program is executed by pressing the F1 button to select
Automatic Mode (the "hand" icon will turn off) and then the F2 button to start the program
(the Program Status indicator will turn on).
To terminate the program, the F2 button is pressed to reset the program (the Program Status
indicator will turn off). Press the F1 button to place the controller in manual mode (the
"hand" icon will turn on).
Use the following procedure to define and run a program:
1.
Turn the system On.
Indicates Ramp / Step Up
Indicates Dwell (Flashing
indicates Dwell End)
Indicates Ramp / Step Down.
Advertisement
Table of Contents
