Table of Contents
Advertisement
the release button and pull the two ends of the
strap apart.
☞ The retaining straps can be adjusted in
length and should not be pulled too tight.
WALKING AID HOLDER
The walking aid is to be removed before fold-
ing the electric travel wheelchair.
The walking aid holder serves for safe carrying
along of a walking aid with a tube diameter be-
tween 20 mm and 30 mm [46 on page 43].
To insert the walking aid, proceed as follows:
1.
Insert the walking aid into the cup of the
walking aid holder.
2. Afterwards press the top of the walking aid
into the clip.
LOADING AND
TRANSPORTATION
The electronic travelling wheelchair must be
switched off before lifting!
Do not use the back support, leg supports or
arm supports to lift the electronic travelling
wheelchair.
Loading
The electronic travelling wheelchair can also
be loaded with the aid of ramps or lifting plat-
forms.
☞ Observe safety and general handling in-
structions < Electric vehicles > chapter
< Ramps and lifting platforms >. – This doc-
ument and further information are avail-
able in the < Information center > on our
website < www.meyra.com >
Ramps and lifting platforms
Observe the operating manual for the ramp
or lifting platform.
20
Observe the manufacturer's information for
the ramp or lifting platform.
The maximum bearing height specified for
the ramp must be greater than the height (h
on page 42) from the ground to the load-
ing surface, e.g. of the car.
The load capacity of the ramp or lifting plat-
form must be higher than the overall permit-
ted weight of the electronic travelling wheel-
chair.
There is a danger of tilting when driving
backwards on ramps!
Transport of people inside a motor
vehicle
Your individual electronic travelling wheelchair
is not suited as a seat for transport inside a mo-
tor vehicle. – For this observe chapter Meaning
of the labels on the electronic travelling wheel-
chair on page 34.
Transport security
All regulations and directions of the respec-
tive transport company are to be observed.
– Ask for these before the transport.
The electronic travelling wheelchair is only
to be secured through the securing points
[41 on page 43]+[42 on page 43]+[43 on
page 43].
☞ The procedure for securing the electronic
travelling wheelchair can be read in the
document < Safety and general handling
instructions electric vehicles > chapter
< Transport in motor vehicles or with con-
veyors >. – This document and further
information are available in the < Informa-
tion center > on our website < www.meyra.
com >.
Advertisement
Table of Contents
