Table of Contents
Advertisement
SEAT PAD
The seat cushion is attached to the seat belt
with velcro fasteners [27 on page 41].
UTENSILS BAG
The utensil pouch is attached to the chassis
frame with velcro fasteners [28 on page 41].
ARM SUPPORTS
The arm supports can be swivelled upward [1].
Swivel up the arm supports
Do not grab into the crossbrace angles to
swivel the arm supports. – Danger of jam-
ming!
For swivelling up the arm supports, pull the
respective locking device (29 on page 41)
outward.
4. Pull the locking device (29 on page 41)
outward.
5.
Swivel the arm support toward the back
and up [30 on page 41].
Swivelling down the arm supports
Swivel the arm supports down slowly [31 on
page 41].
☞ In doing so, the locking device must vis-
ibly and audibly snap into place (32 on
page 41).
☞ Check for correct locking. – The arm sup-
port may not let itself be lifted.
FOLDING/UNFOLDING
Do not grab into the cross sections for fold-
ing/unfolding. – Danger of jamming!
For storage or transport e. g. in a motor vehicle
the electronic travelling wheelchair can folded
easily [33 on page 41].
Folding
1.
Switch the electronic travelling wheelchair
off.
☞ Press the ON/OFF key to switch on the op-
erating module (4 on page 39).
2. Swivel the folding lock upwards/inwards
(34 on page 42).
3.
Fold the footboard inwards [19 on
page 40].
4. Switch to push mode [2 on page 39].
5.
Operate the cable pull (35 on page 42)
and fold the electronic travelling wheel-
chair together toward the front [33 on
page 41].
☞ The parts that might have been detached
for the transport must be carefully stowed
and carefully attached again before the
next journey!
6. Secure the electronic travelling wheelchair
from unintentional unfolding with help of
the folding fixation.
17
Advertisement
Table of Contents
