Table of Contents
Advertisement
SELECTING THE OPERATION
In order to obtain operational readiness of the
electronic travelling wheelchair the following
directions are to be carried out in the indicated
order.
1.
Unfold the electronic travelling wheelchair
if applicable.
2. Before first use, charge the drive batteries
completely through the operating module
[13 on page 39].
☞ Therefore observe chapter Battery
charging procedure on page 15.
3.
Check whether the battery plug is insert-
ed correctly into the battery socket (14 on
page 40).
4. Switch the drive motors to the drive mode
[1 on page 39]. – For this engage the
brakes.
☞ Observe chapter Locking the brakes on
page 9.
5.
Check if the arm support stopper is turned
downward (15 on page 40).
6. Switch the operating module on.
Press the On/Off-key (4 on page 39) on
the control panel of the operating module.
☞ Therefore observe chapter Switching
the operating module on on page 10.
14
PRE-OPERATION CHECKS
Before starting to drive, the following should
be checked:
1.
The technical condition of the electronic
travelling wheelchair.
☞ Check screwed connections, e. g.
through slight movements of the com-
ponents, like arm supports, back sup-
port.
☞ Through a general visual check.
2. The battery charging condition.
3.
The setting of the preselected final speed.
☞ Therefore observe chapter Preselectable
maximum speed on page 11.
Battery charging condition
After activation the battery gauge (5 on
page 39) shows the battery charging condi-
tion.The displayed value depends on the sur-
rounding temperature, the age of the battery
as well as their type of strain and is therefore to
be observed with limitations.
☞ The lithium ion batteries should be
charged immediately when the red LED of
the battery gauge is blinking.
☞ Therefore observe chapter Fault correction
on page 23.
☞ View chapter Battery voltage on page 10.
Advertisement
Table of Contents
