Resetting Change Engine Oil Service Interval Message - Navistar MaxxForce 7 Operation And Maintenance Manual

SECTION 5 – MAINTENANCE SCHEDULE AND SERVICE PROCEDURES
Service Procedures (cont.)
ENGINE OIL AND FILTER (cont.)
18. Recheck oil level and add oil to bring oil level within the upper
half of the crosshatched operating range on oil level gauge.
19. Reset the change engine oil service interval message. See

Resetting Change Engine Oil Service Interval Message

(page 76).
RESETTING CHANGE ENGINE OIL SERVICE INTERVAL
MESSAGE
Reset the Service Interval Message (change engine oil) per the
following procedure:
1. If not already done, set the parking brake.
2. Turn ignition switch to ON.
3. Turn CRUISE ON.
4. Turn CRUISE OFF.
5. Turn CRUISE ON.
6. Very rapidly push the resume switch four times and then hold
down on the fifth time for 4 seconds.
7. The operation from the time the CRUISE is turned ON for the
second time to the fifth activation of the resume switch must
take place within 6 seconds. If you fail to reset the message,
repeat the process.
Page 76
8. The Change Engine Oil Service Interval message should
clear and reset for the next service interval.