Switches And Levers - Toyota 30-5SDK5 Operator's Manual

en-8
HST oil filter warning lamp
If the HST oil filter becomes clogged, a red
lamp lights to warn the operator. This lamp also
lights when the ignition switch is turned to the
ON position, but goes off again when the engine
starts. When the lamp comes on, immediately
stop operation, and replace the HST oil filter.
Never continue to operate the vehicle after the
lamp has come on, or an HST breakdown may
occur.
Note:
There is nothing unusual if the lamp comes on
when the engine runs slowly but goes out with
the engine speed increased.

SWITCHES AND LEVERS

(1) (2) (3)
(2) (3)
(4)
(5) (6)
(1) GLOW
(2) OFF
(3) ON
(4) START
(5) 3TNV88 engine models
(6) 2Z, 1DZ-II engine models
Caution Caution
• Never operate the ignition switch without
first sitting on the seat. Otherwise, the
vehicle could start to move uncontrolled,
causing an accident.
• Do not leave the switch in the ON position
when the engine is stopped. Leave the
switch in the ON position during engine
operation.
• Do not turn the switch to the START
position while the engine is running. This
may damage the starter motor.
Ignition switch
The ignition key is inserted with the teeth facing
upward.
OFF ............ Engine stop position.
Key inserting and withdrawal is
(4)
performed in this position.
ON .............. Engine operation position.
Located one position clockwise
from the OFF position.
When the engine is started, the
intake heater will heat up. (2Z,
1DZ-II engine models)
START ....... Engine start position.
Located one position clockwise
from the ON position. After
engine start, release the key and it
will return to the ON position
automatically.
GLOW ....... Intake heater operating position.
When the engine is in cold state,
the air in the intake manifold is
preheated by the glow plug.
Turn the ignition switch counter
clockwise from the OFF position.
The engine can easily be started
when the preheating indicator
lamp goes off. (3TNV88 engine
models)
After engine start, release the key and it will
return to the I [ON] position automatically.
• Do not hold the switch in the START
position for more than 15 seconds.
Return the switch to the OFF position
and wait at least 30 seconds prior to
attempting restart.
• In case of the anti-restart ignition switch
(optionally available), be sure to shift the
switch to the [OFF] position before
attempt to start the engine again.