Transportation - Toyota 30-5SDK5 Operator's Manual

TRANSPORTATION

(1)
(1) within 15°
(2)
α
β
β
α
(1)
(3)
Use of a special platform is desirable for load-
ing-unloading of the vehicle for transportation.
When gangplanks have to be used, try safe
operation, paying attention to the following
points.
1. Stop the engine, apply the parking brake
and block tires of the truck.
2. Set left and right gangplanks so that the
truck and the vehicle are centered.
Caution Caution
Use 450 mm or wider gangplanks which can
sufficiently endure the vehicle weight. Fasten
them firmly to the truck bed by using proper
fittings. Install them without level difference
between the left and right, and limit the
board inclination within 15°.
3. Adjust the vehicle direction before getting
on the gangplanks, and load the vehicle
slowly by backward traveling.
Caution Caution
• Never change the direction on the gang-
planks.
• Always assign a guide and carefully oper-
ate for ascending and descending on the
gangplanks.
4. Set the parking brake switch to the ON
position, fix the vehicle body to the truck
bed with wire ropes and use wheel blocks
to prevent vehicle movement during trans-
portation. Bring the bucket into close con-
tact with the truck bed.
Fixing method
Fix the body to the truck bed as described
below.
The fixed angle and rope tension of the wire
rope are as shown in the table below.
(reference)
<Fixed angle> <Fixed rope tension>
(1) -α: 28°/ β: 70° (1) :1565kgf
30-5SDK5
(2) -α: 20°/ β: 40° (2) : 785kgf
(1) -α: 42°/ β: 45° (1) :1310kgf
·
30-5SDK8 9
(2) -α: 15°/ β: 40° (2) :1295kgf
(1) -α: 37°/ β: 45° (1) :1390kgf
·
30-5SDK10 11
(2) -α: 15°/ β: 40° (2) :1405kgf
α
β
α
(1)
β
(4)
(2)
α
β
α
β
(1)
(5)
(3) 30-5SDK5
(4) 30-5SDK8 · 9
(5) 30-5SDK10 · 11
(6) (7)
(6) (7)
(6) 30-5SDK5
(7) 30-5SDK8 · 9 · 10 · 11
Caution Caution
Use a sufficiently strong wire rope for fix-
(2)
ing.
Use lifting hooks (option) when lifting the
vehicle.
(Front side) (30-5SDK5)
Pass wire ropes through holes on both side of
the front of the frame, and fix the body firmly
to the truck bed.
(Front side) (30-5SDK8 · 9 · 10 · 11)
Pass wire ropes through holes on both sides of
the fender, and fix the body firmly to the truck
bed.
(Rear side)
Pass a wire ropes through the left and right rear
hooks for fixing to the bed.
en
en-33