Caution Plates - Toyota 30-5SDK5 Operator's Manual

Interlock system
The interlock system is a system that does not
allow the vehicle to travel and perform material
handling operations unless all of the following
conditions are met:
• Ignition switch should be turned ON;
• Seat switch should be turned ON;
• Seat bar should be lowered into position;
• Operation switch should be turned ON.
Caution Caution
If the interlock system activates during vehi-
cle operation, the vehicle movement will stop.
During operation, do not turn OFF the seat
switch or the ignition switch and do not raise
the seat bar.
Interlock system for traveling
When any of the following situations arise
whilst the vehicle is in motion, the brake will
engage and the vehicle will stop.
• When the ignition switch is turned OFF.
• When the seat bar is raised.
• When the parking brake switch is turned
ON.
• When the engine stalls.
Note:
• When the operation switch or the parking
brake switch is turned ON during traveling,
the brake can be disengaged when the engine
is started and the operation switch is turned
ON again.
• When the ignition switch is turned OFF, the
seat bar is raised or the engine stalls, after
restoring the appropriate operational condi-
tions, if the engine is started and the opera-
tion switch is turned ON again, the stopping
status can be released.
Interlock system for material handling
When any of the following situations arise dur-
ing material handling operations, this system
will lock the material handling pedals (lift,
dump) preventing material handling operations
from being performed.
• When the ignition switch is turned OFF.
• When the seat bar is raised.
• When the operator leaves the seat and the
seat switch is turned OFF.
• When the engine stalls.
Note:
When the material handling pedals (lift, dump)
lock during material handling operations as a
result of any of the above situations, after restor-
ing the appropriate operational conditions, if the
engine is started and the operation switch turned
ON, the material handling pedals (lift, dump)
lock can be released.
Interlock system for material handling
(Material handling hand control vehicle: Option)
When any of the following situations arise dur-
ing material handling operations, this system
will disable the lifting and dumping operations
of the steering control levers preventing mate-
rial handling operations from being performed.
• When the ignition switch is turned OFF.
• When the seat bar is raised.
• When the operator leaves the seat and the
seat switch is turned OFF.
• When the engine stalls.
Note:
When the operations of the steering control
levers become disabled as a result of any of the
above situations, after restoring the appropriate
operational conditions, if the engine is started
and the operation switch turned ON, the lifting
and dumping operations of the steering control
levers can be enabled.

CAUTION PLATES

Caution plates are attached on a vehicle. Before driving it, please be sure to read them thoroughly.
(The sample shows those of an English version.)
Y O U W I L L B E S E R I O U S LY I N J U R E D O R K I L L E D I F Y O U D O N O T F O L L O W T H E S E R U L E S .
DO NOT ATTEMPT REPAIRS UNLESS YOU ARE TRAINED AND AUTHORIZED.
LOWER LIFT ARMS TO GROUND OR USE LOCK PIN. REMOVE KEY AND SET PARKING BRAKE.
KEEP BODY, TOOLS, AND CLOTHES AWAY FROM MOVING OR HOT PARTS. EXHAUST, AND ELECTRICAL CONNECTIONS.
CHECK ENGINE COMPARTMENT FOR OIL, FUEL, OR ANYTHING THAT COULD BURN.
DO NOT OPEN RADIATOR CAP WHEN ENGINE IS HOT.
DO NOT USE HANDS TO CHECK FOR HYDRAULIC LEAKS. WEAR GLOVES AND GOGGLES. AND USE CARDBOARD.
DO NOT USE ETHER OR ANY OHER STARING FLUIDS.
EXHAUST GAS CAN KILL YOU. RUN ENGINE ONLY IN WELL VENTILATED AREAS.
CLOSE AND LATCH DOOR BEFORE PUTTING LOADER IN SERVICE.
SEE OPERATOR'S AND SERVICE MANUALS FOR MORE IMPORTANT INFORMATION.
FILL ONLY WHEN ENGINE OFF
NO SMOKING ALLOWED
57762-24800-71
( )57832-42801-71
en-3
en