Table of Contents
Advertisement
4.
Open right access door.
5.
Tilt blade as needed so there is enough room
to adjust stop bolt.
6.
Loosen jam nut on 45° stop bolt (see Figure
108) then adjust stop bolt in or out according
to how far off blade was from 45°.
45° Stop Bolt
Figure 108. 45° stop bolt and jam nut.
Continue adjusting stop bolt until it contacts
7.
cabinet when blade is at 45°, then tighten jam
nut.
8.
Close right access door.
Arbor Height Stop Bolt
The arbor height stop bolt shown in Figure 109
controls the upper and lower limits of arbor travel.
The position of this bolt is factory set, so it does
not need to be adjusted.
Lower Travel
Bolt
Figure 109. Arbor height limit stops.
Model G1023RL Series (Mfd. Since 02/21)
Jam Nut
Miter Slot to Blade
Parallelism
Your table saw will give the best results if the
miter slot is parallel with the blade. If these com-
ponents are not exactly parallel with each other,
your cuts and your finished work will be lower in
quality, but more importantly, the risk of kickback
will be increased.
Tools Needed
Adjustable Square ............................................. 1
Metal Shim Stock .............................. As Needed
Marker ............................................................... 1
Hex Wrench 8mm .............................................. 1
To adjust blade parallel to miter slot:
1.
DISCONNECT MACHINE FROM POWER!
2.
Raise blade to maximum height and tilt it to
90°.
3.
Measure from miter slot to a carbide tip on
blade, as shown in Figure 110.
STEP A
Blade tilted to 90º
Front
Figure 110. Measuring distance from miter slot
to carbide tip of blade.
4.
Mark carbide tip with a marker where you
made this measurement.
The saw blade is sharp. Use extra care or
wear gloves when handling the blade or
working near it.
Qty
-67-
Advertisement
Table of Contents
