Table of Contents
Advertisement
❏ On the Device Settings sheet of the printer's Properties dialog box, make sure that
SEND CTRL-D Before Each Job and SEND CTRL-D After Each Job are set to No.
❏ TBCP (Tagged binary communications protocol) cannot be used as the Output
Protocol setting.
❏ On the Job Settings sheet of the printer's Properties dialog box, make sure to clear the
Job Management On check box.
Using the PostScript Printer Driver with Macintosh
Installing the PostScript printer driver
Follow the steps below to install the PostScript printer driver.
Note:
Make sure that no applications are running on your Macintosh before installing the printer driver.
For Mac OS X users
Note:
Make sure that Printer Setup Utility (for Mac OS X 10.3 and 10.4) or Print Center (for Mac OS X
10.2) is not open.
1. Insert the printer software CD-ROM into your CD-ROM drive.
2. Double-click the CD-ROM icon.
3. Double-click Mac OS X, then double-click PS Installer.
Note:
For Mac OS X 10.2, if the Authenticate window appears, enter the user name and password for
an administrator.
4. The Install EPSON PostScript Software screen appears, click Continue, then follow
the on-screen instructions.
5. Easy Install is displayed on the screen. Click Install.
Note:
For Mac OS X 10.3 and 10.4, if the Authenticate window appears, enter the user name and
password for an administrator.
6. When installation is done, click Close.
Using the PostScript Printer Driver
121
Advertisement
Table of Contents
