Using The Postscript Printer Driver With Macintosh - Epson AcuLaser C9300N User Manual

Accessing the PostScript printer driver
You can change the PostScript printer driver settings in the PostScript printer driver. To access the
printer driver, see "Accessing the printer driver" on page 173.
Using AppleTalk under Windows 2000
Use the following settings if your machine is running Windows 2000, and the printer is connected
through an network interface using the AppleTalk protocol:
❏ Select PS3 as the Network setting in the printer's emulation mode. For details about the settings,
see the Network Guide.
❏ On the Device Settings sheet of the printer's Properties dialog box, make sure that SEND CTRL-D
Before Each Job and SEND CTRL-D After Each Job are set to No.
❏ TBCP (Tagged binary communications protocol) cannot be used as the Output Protocol setting.

Using the PostScript printer driver with Macintosh

Installing the PostScript printer driver
Note:
Make sure that no applications are running on your Macintosh before installing the printer driver.
For Mac OS X users
Note:
Make sure that Print & Fax (for Mac OS X 10.5 or later) or Printer Setup Utility (for Mac OS X 10.4) is
not open.
1. Insert the printer Software Disc into your CD/DVD drive.
2. Double-click the CD-ROM icon.
3. Double-click Adobe PS, then double-click PS Installer.
4. The Install EPSON PostScript Software screen appears, click Continue, then follow the on-screen
instructions.
5. Easy Install is displayed on the screen. Click Install.
Epson AcuLaser C9300 Series
About the Printer Software
User's Guide
187