Mitsubishi GX50A Operator's Manual page 6

SAFETY/DECALS
9. Before starting any work on electrical
equipment or work that may cause you
to touch the electrical parts accidentally,
first disconnect the battery cables. Never
remove the rubber cap cover at the
positive terminal of the battery cable
end. Before connecting the battery to
the charger, make sure that the charger
switch is in "OFF" position.
Be sure to connect the charger to the
correct terminals on the battery (positive
to positive, negative to negative).
A great amount of hydrogen gas is
generated by the battery when it is being
charged. Take precautions against fire: Do
not have any exposed flame in the area
where you are working.
Be sure not to cause any leakage of the
electrolyte, since it will corrode the skin or
clothing. In case of accident as described
below, immediately seek first aid, and see
a doctor immediately for proper treatment.
a) If the diluted sulphuric acid from the
battery has gotten into the eyes:
Clean the eyes with a lot of clean running
water for more than 15 minutes, while
opening the eyes widely, and see a doctor
immediately for proper treatment.
b) If diluted sulphuric acid from the battery
has been swallowed: Rinse the mouth
with clean water immediately, and drink a
lot of raw eggs or milk. Lie down quietly.
see a doctor immediately for proper
treatment.
c) If diluted sulphuric acid has gotten on the
skin of clothing: Wash away the diluted
sulphuric acid completely with a lot of
clean running water and neutraize with
soap solution. Then rinse with water.
d) If the diluted sulphric acid is spilled: Wash
away with a lot of water or neutralize with
slacked lime or bicarbonate of soda.
10. Stop the engine and make sure the
rear PTO shift lever is in Neutral before
performing any of the following services,
including.
a) Removal of the propeller shaft between
PTO and any attachment.
b) Adjustment of PTO drive train and hitch.
c) Adjustment or cleaning of PTO driven
attachment.
11.The steering wheel always has built-in
play to some extent, which is required for
smooth meshing of sector gear and pinion
gear.
Always inspect the amount of the play. Do
not operate the tractor if there is too much
or too little play in the steering.
iv