Table of Contents
Advertisement
When
lamp is turned off, set the key to
<
>.
Release the key immediately once the engine
is started. The key returns to <
automatically.
Manual
OFF
HEAT&ON START
HEAT&ON
When
lamp and
the operation is in order.
If not turned off, stop the engine immediately
and inspect.
Engine Oil Lamp
Charge Lamp
Set the engine revolution at 1,500 rpm
approximately to perform a warm-up operation.
(Five minutes approx.)
> position
Manual
Automatic
Return
Starter Key Switch
MN00005_A
lamp are turned off,
Dimmer Lamp
MN00043_A
OPERATION PROCEDURE
NOTE
- The engine does not start if the clutch pedal
is pressed completely.
- Do not set the key to <
the engine is rotating. Otherwise, it may
cause a failure.
- When starting operation is repeated,
lamp is not lit. Also, when restarting the
engine immediately after the engine stops, it
is not lit, or it is lit for a short time; however,
it is caused by activation of protecting
circuit and not a failure.
- Be sure to perform a warm-up operation
regardless of the temperature. If the tractor
is operated before the engine is warmed up
sufficiently, the service life of the engine is
shortened.
23
> (START) when
Advertisement
Table of Contents
