Console; Console Layout And Controls; Accessing The Odometer And Hour Meter; Setting Units (U.s. Standard/Metric) - Precor Energy Series Service Manual

Console

Console Layout and Controls

1 SMART DISPLAY
4 ENTER
7 STOP
10 LOWER WINDOW

Accessing the Odometer and Hour Meter

Use the following steps to access the Odometer and Hour Meter values.
1. Set the ON/OFF switch in the "ON" position and remove the safety key from the console.
Allow the internal power supply to discharge, approximately 10 seconds, and then replace
the safety key on the console. Within 2 seconds of replacing the safety key, press the
STOP, INCLINE UP, SPEED DWN keys, sequentially.
2. The Odometer in miles or kilometers will be displayed in the DISTANCE window of the
display.
3. The hour meter will be displayed in the TIME window.
4. The upper PCA software version will be displayed in the main window.
5. Press the STOP key to exit this program.

Setting Units (U.S. Standard/Metric)

Use this procedure to set the parameter units to U.S. Standard or Metric.
1. Set the ON/OFF switch in the "ON" position and remove the safety key from the console.
Allow the internal power supply to discharge, approximately 10 seconds, and then replace
the safety key on the console. Within 2 seconds of replacing the safety key, press the
STOP, INCLINE DWN, SPEED UP keys, sequentially.
2. Press the INCLINE UP key to toggle the selection between U.S. Standard and METRIC.
6. Press the ENTER key to save the selection. Press the STOP key to exit.
3.
© 2014 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
2 PROGRAMS
5 INCLINE CONTROL
8 CENTER WINDOW
3 QUICKSTART
6 SPEED CONTROL
9 WORKOUT STATISTICS
7Page 7 of 54