Table of Contents
Advertisement
Shark Spot Two
Rigging
The device can be positioned on a flat surface or mounted to a truss or other rigging structure in any
orientation. Make sure that all loads are within the pre-determined limits of the supporting structure.
CAUTION
Restrict the access under the work area during rigging and/or derigging.
To mount the device, follow the steps below:
Install the safety eye, supplied with the device, in the safety eye hole (12), as shown in Fig. 09. Make
sure that you use clamps suitable for attaching the device to a truss.
Fasten the quick lock bracket, supplied with the device, on the mounting holes for quick lock
bracket (11), as shown in Fig. 10.
Attach the device to the supporting structure. Make sure that the device cannot move freely.
Secure the device with a secondary suspension, for example a safety cable. Make sure that the
secondary suspension can hold 10 times the weight of the device. If possible, the secondary
suspension should be attached to a supporting structure independent of the primary suspension. Put
the safety cable through the safety eye as shown in Fig. 10.
Product code: 45030
14
Fig. 09
Fig. 10
Advertisement
Table of Contents
