Download Print this page

Reversing Door - Electrolux EWMED70JSS Installation Instructions Manual

Front-load gas & electric dryer
Hide thumbs

Advertisement

Table of Contents
Preparing to reverse door swing
1 Be sure you have adequate swing area before reversing door.
2 You will need a screw driver with a #2 square bit.
3 Protect fl at work surface, such as top of dryer or fl oor near dryer,
with a soft cloth or towel.
4 Be sure dryer is unplugged from power source!
Failure to disconnect power source before servicing
could result in personal injury or even death.
Removing door and hardware
A) Removing Trim Ring
1 Open door to 90 degree angle.
2 Remove and save trim plug and long,
course-thread, panhead screw.
3 Close door.
4 Rotate door trim approximately ¾" counter-
clockwise and pull ring away from door.
WARNING
ELECTRICAL SHOCK HAZARD

Reversing Door

Tools needed:
B) Removing Door from Hinge
1 Reopen door to 90 degree angle.
2 Remove 4 long, course-thread, counter-sunk
hinge screws from door.
3 While supporting the weight of the door
with both hands, separate the door from the
hinge.
4 Gently place door face down on fl at, covered
work surface.
Screwdrivers with
#2 square &
straight bit
19

Hide quick links:

Advertisement

Table of Contents
loading

  Related Manuals for Electrolux EWMED70JSS