Reversing The Door - Electrolux ENV06 Service Manual

14 REVERSING THE DOOR

1. Unfasten the screws fixing the hinges to the unit (1),
remove the door.
2. Unfasten the screws fixing the hinge covers (2) and fix them
where the door hinges used to be (1).
3. Remove the worktop.
4. Remove the left and right sides.
5. Remove the front opening plug (4) bearing in mind that to
extract it you have to press the hooks fastening it to the unit
towards each other.
6. Unfasten the screws fixing the door lock (3) to the unit and
extract the door lock.
7. Disconnect the connector from the door lock.
8. Remove the tape (if there is any) holding the wires and
separate the door lock wires from the other wires.
9. Replace the tape as you found it (on the other wires).
10. Insert the general wires into the hooks located in the air
conduit, and arrange them so that they are parallel to the
front and are unable to come into contact with the drum.
11. Lock the wires to the hook using a cable clamp.
12. Remove the door lock wires from their original position (1)
and insert them under the front brush (2), fixing them in
the hooks in the conduit (3) and pulling the wires out at
the opposite side of the unit.
13. Fasten any excess door lock cable to the cable guard (6),
using a cable clamp.
ADL 2010 / 01 55/57 599 72 63-27