Stiga e-PARK 220 Workshop Manual page 37

WORKSHOP MANUAL
e-PARK 220
9. Slightly lift the front part of the plate (13) and,
while holding it up, move it forwards so that the
belt (6) is freed from the clutch pulley (14).
10. Carefully remove the plate (13) and the motor
from the left side of the machine.
IMPORTANT If the electric cables have been
disconnected from the ACE-0 control unit,
take the utmost care to ensure that they can
run freely, without encountering obstacles or
hindrances when removing the motor.
When assembling, repeat the operations de-
scribed above backwards, taking extreme care
to:
– Reassemble the plate (13) making sure that
the belt (6) remains firmly in the groove of the
clutch pulley (14).
– Reposition the cable (15) against the motor, so
that it is contained inside the left fold of the sup-
port plate (13);
– Restore the original cable routing and fasten-
ing the cables with the cable clamp (7) and ca-
ble clip (8);
– Hook the end (4a) of the spring correctly (4)
into the half-moon hole in the left wall of the
frame.
CHAPTER
6 - BLADES MOTOR - CLUTCH AND PTO
13
14 6
13
13
4
EDITION PAGE
2018 37 /
84
12
15
12
4a