Stiga e-PARK 220 Workshop Manual page 32

WORKSHOP MANUAL
e-PARK 220
4. Disconnect the three cables (2) - (3) - (4) of
the three-phase power supply and mark them
in such a way that there are no errors when
reconnecting them.
5. Disconnect the connector (5).
6. Pull out the spring pin (6) and remove the link-
age (7) of the brake release device with the
help of a 3 mm pin punch.
7. Undo the screw (8) the two screws (9) and re-
move the reaction braket (10).
WARNING! The unit is secured to the
frame by four screws. Loosen the screws
carefully, adequately supporting the
transmission unit so as not to cause it
to fall.
8. Unscrew the four screws (11) and the trans-
mission unit (12) can be removed from the ma-
chine
When assembling, repeat the steps described
above in reverse order, taking care to:
– properly reposition the spacer (13) and the
locating washer (14) on each axle inside the
wheels;
– tighten the four screws (11) with a click-type
torque wrench set to 25 Nm;
– observe the position of the three cables (2) - (3)
- (4) of the three-phase power supply which, if
reversed, would prevent the motor from run-
ning.
CHAPTER
5 - TRANSMISSION UNIT - WHEELS
5
14
2 3 4
7
9
13
EDITION PAGE
2018 32 /
84
6
9
8 10
12
11 11