Stiga e-PARK 220 Workshop Manual page 49

WORKSHOP MANUAL
e-PARK 220
Situation / Ac-
Component
Cutting deck lifting Disconnected /
switch Check connector
terminals
Cruise control switch Disconnected /
(Cruise Control) Check connector
terminals
Bipolar CURRENT Disconnected /
PRESENCE CON- Check connector
NECTOR (under the terminals
bonnet, connected
to the electrical plug
wiring)
Bipolar CURRENT Disconnected /
PRESENCE CON- Check connector
NECTOR (under the terminals
bonnet, connected
to the electrical plug
wiring)
223V three-pole VOLT- Disconnected /
AGE or faston connec- Check connector
tor on the filter (under terminals
the hood, between
the charger and the
electric plug)
223V three-pole VOLT- Disconnected /
AGE or faston connec- Check connector
tor on the filter (under terminals
the hood, between
the charger and the
electric plug)
CLUTCH connector Disconnected /
(black connector near Verify terminals
the blade motor) on connector
FAN connector Disconnected /
Check connector
terminals
"TRACTION CABLE Disconnected /
CONNECTOR A Check connector
(black bipolar con- terminals
nector close to AC-0)
"SAFETY BRAKE
ERROR" White bipolar
connector on traction
Check electrobrake
"TRACTION CABLE Disconnected /
CONNECTOR B Check connector
(white 8-pin connector terminals
near AC-0)
MOTOR TRACTION Disconnected /
TEMPERATURE Check connector
(black bipolar connec- terminals
tor on the traction)
8 - ELECTRICAL SYSTEM
Display Indications on
"SERVICE" Mode
tion
AC-0 ACE-0
0 0
0 0
0 0
0 0
- -
0 0
0 0
0 0
254 224
65 0
65 0
CHAPTER
Display indications
on "OPERATOR"
mode
Notes
The icon The icon "CUT-
"CUTTING TING DECK
DECK UP" UP" does not appear
does not ap- when the pedal is
pear when the pressed down.
pedal is pressed
down.
The The icon
"CRUISE" "CRUISE" does
icon does not not appear
appear
"PP" is always The icon "PP"
deactivated. does not ap-
pear
"PP" is always Display ON,
deactivated. the icon SEAT
appears
The charging
phase does not
appear
Display OFF Display OFF
"PP" ON The "PP" icon
appears.
"BLADE" ON The "PTO" icon
appears.
GENERAL ER-
ROR appears
MOTOR TEMP (P) struck
=180° even through
when the motor
is cold
MOTOR TEMP OVERHEAT-
=180° even ING
when the motor
is cold
EDITION PAGE
2018 49 /
84
Effects on the
machine
OPC does not work;
no warning light on
theSWITCH OPC if
pressed
The speed maintainer
device does not work
Charge with plug on
the vehicle, not on the
wall
Vehicle does not
charge (charge with
plug on vehicle and
wall); display ON; key
OFF
Vehicle does not
charge (charge with
plug on vehicle and
wall); display OFF; key
OFF
Vehicle does not
charge (charge with
plug on vehicle and
wall); display ON; key
ON
The blade/belt does
not work, but the blade
motor works
The traction control-
ler's FAN does not
work
Traction does not work
Traction does not work
Traction does not work