Table of Contents
Advertisement
High Level 2-Channel Lab Scope with built in Multimeter
1.1 Product Profile
This MAX2CSCOPE is composed of hardware and software. Hardware includes MAX2CSCOPE module
and connection wire. The Oscilloscope and Multimeter APP are installed on diagnostic tool.
Automotive oscilloscope can make the auto repair technician to quickly judge the faults on automotive
electronic equipment and wiring, and the oscilloscope sweep speed is far greater than the signal
frequency of such vehicles, usually 5-10 times of the measured signal. The automotive oscilloscope not
only can quickly acquire the circuit signal, but also can slowly display the waveform to observe and
analyze. It can also record and store the tested signal waveform.
Multimeter is mainly used to test voltage, current and resistance. It only does simple measurements. In
this way it can determine if the device is operate normally or fault and if the circuit is complete.
1.2 Accessories Included
Common accessories are same, but for different destinations, the accessories may vary. Please consult
from the seller or check the package list supplied with this tool together.
No.
MAX2CSCOPE
1
BNC to 4mm Test Leads
2
Multimeter test pen (black
3
+ red)
1 Overview
Name
It is dedicated cable used to connect sensor and
MAX2CSCOPE and test all types of vehicle signal. If is
fitted with wide range probe, clip and hook and 4mm
connector that can plug in wire end.
It shall be connected to COM and V/Ω terminal of the
sensor module when using multimeter.
Description
1
MDMAX2CSCOPE
A
Advertisement
Table of Contents
