Current Measurement; Resistance Measurement - Matco Tools MAXIMUS MDMAX2CSCOPE Instruction Manual

High Level 2-Channel Lab Scope with built in Multimeter
Numerical mode
Waveform mode
Open waveform
Save waveform
5. Tap Start, numerical value will be displayed directly on the diagnostic tool.
Warning: the tip of the test pen is metal, do not touch it with hands during measurement, otherwise it
might cause electricity shock and affect measurement results.

4.1.2 Current Measurement

DC current and AC current measurement apply the same connection method.
1. Tap Toolbox -> Multimeter on the diagnostic tool to enter the following screen.
2. Select DC current/AC current and corresponding range, tap Not connected to search for
MAX2CSCOPE. When it is successfully connected, the diagnostic tool will display connection status.
3. Insert black test pen into COM terminal of MAX2CSCOPE. If measured current is above 400mA,
insert red test pen into A terminal of MAX2CSCOPE. If measured current is below 400mA, insert red
test pen into mAμA terminal of MAX2CSCOPE.
4. Connect black and red test pen to tested point. Keep test pen attached to it firmly.
5. Tap "Start", numerical value will be displayed directly on diagnostic tool.

4.1.3 Resistance Measurement

1. Tap Toolbox -> Multimeter on the diagnostic tool to enter the following screen.
Displays the measurement result in numerical form.
Displays the measurement result in waveform form.
Open saved waveform file.
Save measurement result as a waveform file.
20
MDMAX2CSCOPE
A