Table of Contents
Advertisement
High Level 2-Channel Lab Scope with built in Multimeter
The MAX2CSCOPE applies edge trigger, which is the most commonly used and effective trigger method.
A clear majority of applications apply this trigger method to trigger waveform. An edge trigger
determines whether the Oscilloscope finds the trigger point on the rising/falling/dual edge of a signal.
When tested signal voltage direction is consistent with preset direction, and value reaches trigger
voltage, the MAX2CSCOPE will be triggered and capture waveform.
Menu
Source
Trigger
In this mode, the user can set the trigger level by directly dragging the Level scroll bar or the icon
the right side of the waveform display area.
3.2.3 Auto-Set
The Oscilloscope has an Auto-set feature that sets up the Oscilloscope automatically to display the input
signal in a best fit.
Tap Auto, the MAX2CSCOPE may change the current settings to display the signal. It automatically
Select channel source of triggered signal.
Level: The electrical level that signals shall exceed when capturing
waveform.
Rise: Trigger on rising edge.
Drop: Trigger on falling edge.
Close: Turning off trigger mode.
Comments/Settings
13
MDMAX2CSCOPE
A
on
Advertisement
Table of Contents
