High Level 2-Channel Lab Scope with built in Multimeter
Multimeter is mainly used to test voltage, current, resistance, diode and Make-and-break. It only does
simple measurements. In this way it can determine if the device is operate normally or fault and if the
circuit is complete.
4.1 Operation
1. First connect the MAX2CSCOPE to power supply.
2. Connection method varies with tested object. Please refer to the following method to test:
4.1.1 Voltage Measurement
DC voltage and AC voltage measurement apply the same connection method.
1. Tap Toolbox -> Multimeter on the diagnostic tool to enter the following screen.
2. Select DC voltage/AC voltage and corresponding range, tap Not connected to search for
MAX2CSCOPE. When it is successfully connected, the diagnostic tool will display connection status.
3. Insert one end of black test pen into COM terminal of MAX2CSCOPE, insert one end of red test pen
into V/Ω terminal of MAX2CSCOPE.
4. Attach black and red test pen tip to tested point. Keep test pen attached to it firmly.
Option descriptions:
Menu
Numerical waveform
mode
4. Multimeter Operation
Displays the measurement result in both numerical and waveform form.
Comments/Settings
19
MDMAX2CSCOPE
A