Table of Contents
Advertisement
High Level 2-Channel Lab Scope with built in Multimeter
Mantenga las superficies del producto limpias y secas.
No desmonte ni vuelva a ajustar el dispositivo. El dispositivo es un dispositivo sellado y no
hay piezas reparables por el usuario final en su interior. Todas las reparaciones internas deben
ser realizadas por agencias de mantenimiento autorizadas o un técnicos autorizados. Los
intentos de desmontar o reinstalar el dispositivo anularán la garantía.
No intente reemplazar la batería interna. La batería recargable interna debe ser reemplazada
por agencias de mantenimiento autorizadas o técnicos autorizados.
This high level 2-channel lab scope with built in multimeter is designed as an add-on module, which
can work with the specific scanner of MATCO family to perform automotive oscilloscope and
multimeter functions.
Do not use this tool outside of the designed intent. Never modify the tool for any other purpose or
use.
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
INTENTED USE OF THIS TOOL
PRODUCT INFORMATION
FCC STATEMENT
iii
MDMAX2CSCOPE
Made in China
to Matco specifications
A
Advertisement
Table of Contents
