Table of Contents
Advertisement
High Level 2-Channel Lab Scope with built in Multimeter
Crocodile Clips
4
Back Probe Pins Suite
5
Type A-Type B USB cable
6
Power adapter
7
User manual
8
1.3 Technical Parameters
1. When used as Oscilloscope
Name
Channels
Bandwidth
Max. sample rate
Timebase
Acquisition mode
Designed to connect the bare terminals or leads.
It can be used to connect sensor and BNC to 4mm Test
Leads, and can easily pierce the insulation of wires to
allow for automotive electrical measurements without
causing damage to the wires. Additionally, they can be
used as pin-tip probes while working with small circuit
boards.
Used to connect MAX2CSCOPE and diagnostic tool,
sending signal acquired by MAX2CSCOPE to diagnostics
tool to display waveform.
Charge the MAX2CSCOPE with included USB cable.
Descriptions
2
10MHz
50MHz/s
200ns~10S
Normal sampling
2
MDMAX2CSCOPE
A
Advertisement
Table of Contents
