GB
• Always disconnect the device
from the power supply before
assembling, disassembling or
cleaning it.
• The equipment is not to be oper-
ated if there are people in the
water. There is a risk of electric
shock.
• Connect the equipment only to
a socket with a RCD (Residual
Current Device) with a rated
current of not more than 30 mA;
minimum fuse 6 amperes.
• Contamination of the liquid can
occur when the lubricant leaks
out.
• See further information in the
section on "Maintenance and
cleaning".
Areas of Application
The dirty water submersible pump is a
drainage pump and designed for trans-
porting water and sewage water (max.
particle size 35 mm) up to a temperature
of max. 35 °C.
It is suitable e.g. for pumping around and
pumping out basins and containers, for
pumping out flooded cellars, and for ex-
tracting water from wells and shafts. This
equipment is not suitable for industrial use.
Industrial use will invalidate the guarantee.
Any other use, not expressly authorised in
these instructions, may cause damage to
the equipment and represent a serious risk
for the user.
The pump is not designed for continuous
operation, for which we do not assume
any guarantee.
The operator or user is responsible for ac-
cidents or damage to other people or their
property.
18
The manufacturer shall not be liable for
damages caused by use other than for
which the equipment is intended or by in-
correct operation.
General Description
The diagram of the most impor-
tant functional elements can be
found on the foldout side.
Scope of Delivery
Carefully unpack the appliance and check
that it is complete.
-
Submersible sewage pump
-
Quick-connect adapter
-
Angle adapter
-
Reducer
-
8 m nylon cord
-
Instruction Manual
Dispose of the packaging material correctly.
You need a hose clamp and a saw
when connecting the hose (see un-
der "Connecting the line"). The tool
is not included. The tool can be purchased
from specialist dealers.
Functional description
The dirty water submersible pump has a
stainless steel casing, a stable suction foot
and a non-corrosive motor shaft. The pump
is fitted with a float switch, which automati-
cally switches the equipment on or off.
The motor is protected from overload by a
thermal safety switch.
Please refer to the following descriptions
for the function of the operating parts.