Table of Contents
Advertisement
MCS-R Control unit
replacing ECS 430P or older control units for
CDM5 & 6
2. MCS-R control unit
2.1
Installation
1) At the rear of the control unit you have to assemble 4 enclosure brackets before mounting it to the wall. Use the four small
5x12 screws.
2) Mount the Control unit approx. 1.7m above the floor (measured from the upper side of the box).
3) Connect the cables from the door leaf and the drive unit, according to the instructions by the wiring diagram.
The control unit is now assembled and ready to be functionally installed. See paragraph "Programming" concerning the
programming procedure.
MCS-R control unit
Installation Manual
5
Hide quick links:
Advertisement
Table of Contents
