Main Control Unit - Assa Abloy Norton 5900 Series Installation And Instruction Manual

Main Control Unit

Main
Control
Board
SPTE
Spring
tension
Opening speed
Closing speed
Note: Arm can be changed in the field by following these
steps:
• Switch power off
• Select arm configuration on the DIP-switches (See Fig. 2)
• Switch power on
Copyright © 2010, 2014 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
Encoder
Motor
5 s
HOT
1.5 s 30 s
ON
1
OPSP CLSP POAS CLTQ HOT
Hold open time
Closing force
Power assist
Synchronizing of double doors (Master & Slave Cable input)
On/Off/Hold Open switch
LRN Teach button
(+) 24VDC (0.4amp) - used with terminal 1 (for accessories)
LOUT Lock-out for OPD (–)
OPD Onboard presence detection
XIMP N/A
IMP
Activation Switches
GND (-) 24VDC
OPD Onboard presence detection (incl. 24 V, LOUT and
Safety Impulse)
LED = Error
2 3 4 5
5
Dip switches shown
in Off position
Arm System Setting
(see below)
SOS Stop on Stall
MAT Safety Mat (By others)
PAG Push & Go
PULL
PUSH
80-9359-0001-020 (01-14) Rev 3
ASSA ABLOY
Figure 1
Figure 2