Advertisement
DAQ Specifications (Cont.)
Counter
Counter chip
N/A
Channels
2 channels (independent)
Resolution
32 bits
Compatibility
TTL level
Internal 20 MHz or external clock (10 MHz max.),
Base Clock
selectable via software
Input Fre-
Max. 10 MHz
quency
Low
Clock Input
High
Low
Gate Input
High
Low
Counter Output
High
Frequency
Measurement
Pulse Width
Measurement
Error in
Advanced
Functions
Pulse Output
PWM Output
Procedures
Installation
iDoor Module Installation
1. Unscrew the bottom plate and back cover.
2. Unscrew the iDoor cover from the back cover as-
sembly.
3. Insert the mini PCIe card into the mPCIe slot.
4. Plug the cable to connect the mini PCIe card and iDoor
IO module.
5. Screw the IO module with the back cover.
6. Screw the back cover and bottom plate back to com-
plete the assembly.
0.8 V max.
2.0 V min.
0.8 V max.
2.0 V min.
0.8 V max. @+15mA
2.0 V min. @-15mA
0.1% when the input signal frequency
is ≥ 40 KHz
0.1% when the input signal frequency
is ≤ 40 KHz
Within 2% when the output frequency
is > 1 MHz
Within 2% when the output frequency
is > 1 MHz
Procedures (Cont.)
Installation
HDD Installation
1. Unscrew the 4 screws and remove the rear cover.
2. Undo the 4 screws affixing the SSD to the rear cover.
3. Replace the SDD with an HDD.
4. Affix the HDD to the rear cover using the 4 screws.
5. Reconnect the SATA and power cables and replace the
rear cover. Secure in place using the 4 screws.
Table Mount Installation
MIC-1816 can be integrated with a table mount for easy
operation. To prevent the system from overheating, the side
of the system with the heat sink must be facing upward.
1. Unscrew the 4 screws affixing the rear cover in place.
2. Align the screw holes of the rear cover with the screw
holes of the table mount. Secure the system to the rear
cover and table mount using the 4 screws.
Declartion of Conformity
This device complies with the requirements in Part 15 of
the FCC rules. Operation is subject to the following two
conditions:
1. The device must not cause harmful interference.
2. The device must accept any interference received,
including interference that may cause undesired opera-
tion.
MIC-1816 Startup Manual 3
Advertisement
